• Start
• Documentation
  • PostgreSQL
  • mnoGoSearch
  • Apache 2.4
  • FreeBSD handbook
  • FreeBSD Manual
  • FreeBSD Source
• Tools
• Search
• Protected Area

plain

FreeBSD manual

keyword 1 2 3 4 5 6 7 8 9 n l

download PDF document: acpi_hpet.4.pdf

HPET(4) FreeBSD Kernel Interfaces Manual HPET(4)
NAME hpet - High Precision Event Timer driver
SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file:
device acpi
The following tunables are settable from the loader(8):
hint.hpet.X.allowed_irqs is a 32bit mask. Each set bit allows driver to use respective IRQ, if BIOS also set respective capability bit in comparator's configuration register. Default value is 0xffff0000, except some known broken hardware.
hint.hpet.X.clock controls event timers functionality support. Setting to 0, disables it. Default value is 1.
hint.hpet.X.legacy_route controls "LegacyReplacement Route" mode. If enabled, HPET will steal IRQ0 of i8254 timer and IRQ8 of RTC. Before using it, make sure that respective drivers are not using interrupts, by setting also:
hint.attimer.0.clock=0 hint.atrtc.0.clock=0 Default value is 0.
hint.hpet.X.per_cpu controls how much per-CPU event timers should driver attempt to register. This functionality requires every comparator in a group to have own unshared IRQ, so it depends on hardware capabilities and interrupts configuration. Default value is 1.
DESCRIPTION This driver uses High Precision Event Timer hardware (part of the chipset, usually enumerated via ACPI) to supply kernel with one time counter and several (usually from 3 to 8) event timers. This hardware includes single main counter with known increment frequency (10MHz or more), and several programmable comparators (optionally with automatic reload feature). When value of the main counter matches current value of any comparator, interrupt can be generated. Depending on hardware capabilities and configuration, interrupt can be delivered as regular I/O APIC interrupt (ISA or PCI) in range from 0 to 31, or as Front Side Bus interrupt, alike to PCI MSI interrupts, or in so called "LegacyReplacement Route" HPET can steal IRQ0 of i8254 and IRQ8 of the RTC. Interrupt can be either edge- or level-triggered. In last case they could be safely shared with PCI IRQs. Driver prefers to use FSB interrupts, if supported, to avoid sharing. If it is not possible, it uses single sharable IRQ from PCI range. Other modes (LegacyReplacement and ISA IRQs) require special care to setup, but could be configured manually via device hints.
Event timers provided by the driver support both one-shot an periodic modes and irrelevant to CPU power states.
SEE ALSO acpi(4), apic(4), atrtc(4), attimer(4), eventtimers(4), timecounters(4)
HISTORY The hpet driver first appeared in FreeBSD 6.3. Support for event timers was added in FreeBSD 9.0.
FreeBSD 14.0-RELEASE-p11 September 14, 2010 FreeBSD 14.0-RELEASE-p11