FreeBSD manual
download PDF document: my.4.pdf
MY(4) FreeBSD Kernel Interfaces Manual MY(4)
NAME
my - Myson Technology Ethernet PCI driver
SYNOPSIS
To compile this driver into the kernel, place the following line in your
kernel configuration file:
device my
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_my_load="YES"
DESCRIPTION
The my driver provides support for various NICs based on the Myson
chipset. The Myson chipset is a variant of the DEC Tulip NIC chipset.
The driver will work with almost any MII-compliant PHY, thus failure to
positively identify the chip is not a fatal error.
HARDWARE
The my driver provides support for various NICs based on the Myson
chipset. Supported models include:
o Myson MTD800 PCI Fast Ethernet chip
o Myson MTD803 PCI Fast Ethernet chip
o Myson MTD89X PCI Gigabit Ethernet chip
SEE ALSO
altq(4), netintro(4), pci(4), ifconfig(8)
HISTORY
The my driver first appeared in FreeBSD 4.6.
AUTHORS
The my driver was written by Myson Technology Inc.
This manual page was written by Hiten M. Pandya <hmp@FreeBSD.org>.
BUGS
The my driver does not support Power Management Events (PME).
FreeBSD 14.0-RELEASE-p11 December 26, 2020 FreeBSD 14.0-RELEASE-p11