FreeBSD manual
download PDF document: qlnxe.4.pdf
QLNXE(4) FreeBSD Kernel Interfaces Manual QLNXE(4)
NAME
qlnxe - Cavium 25/40/100 Gigabit Ethernet & CNA Adapter Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device qlnxe
To load the driver as a module at boot time, place the following line in
loader.conf(5):
if_qlnxe_load="YES"
DESCRIPTION
The qlnxe driver supports IPv4 checksum offload, TCP and UDP checksum
offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
IPv6, Jumbo frames, VLAN Tag, Receive Side scaling, HW and Soft LRO. For
further hardware information, see http://www.qlogic.com/.
HARDWARE
The qlnxe driver supports 25/40/100 Gigabit Ethernet & CNA Adapter based
on the following chipsets:
o QLogic 45000 series
o QLogic 41000 series
SUPPORT
For support questions please contact your Cavium approved reseller or
Cavium Technical Support at http://support.qlogic.com, or by E-mail at
<support@qlogic.com>.
SEE ALSO
altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The qlnxe device driver first appeared in FreeBSD 11.1.
AUTHORS
The qlnxe driver was written by David C Somayajulu at Cavium Inc.
FreeBSD 14.0-RELEASE-p11 May 9, 2017 FreeBSD 14.0-RELEASE-p11