FreeBSD manual
download PDF document: qlxgbe.4.pdf
QLXGBE(4) FreeBSD Kernel Interfaces Manual QLXGBE(4)
NAME
qlxgbe - QLogic 10 Gigabit Ethernet & CNA Adapter Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device qlxgbe
To load the driver as a module at boot time, place the following line in
loader.conf(5):
if_qlxgbe_load="YES"
DESCRIPTION
The qlxgbe driver supports IPv4 checksum offload, TCP and UDP checksum
offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling, ability to select
either HW or Software LRO, when LRO is enabled (default HW LRO). For
further hardware information, see http://www.qlogic.com/.
HARDWARE
The qlxgbe driver supports 10 Gigabit Ethernet & CNA Adapter based on the
following chipsets:
o QLogic 8300 series
SUPPORT
For support questions please contact your QLogic approved reseller or
QLogic Technical Support at http://support.qlogic.com, or by E-mail at
<support@qlogic.com>.
SEE ALSO
altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The qlxgbe device driver first appeared in FreeBSD 10.0.
AUTHORS
The qlxgbe driver was written by David C Somayajulu at QLogic
Corporation.
FreeBSD 14.0-RELEASE-p11 April 1, 2013 FreeBSD 14.0-RELEASE-p11